Uncategorized

Updates to Burro self-driving platform

I've been busy implementing some cool updates to Burro, the self-driving RC car/robot platform I'm building. Here's a summary: The Adafruit Motor HAT is now supported in addition to NAVIO2. Both boards are fully supported , and in fact you can use the same SD card in different cars/robots, without the need to reinstall anything, as detection of boards is done…

Build an Autonomous Car with RPi, NAVIO2 and Tensorflow/Keras, Part II: The Software

In the previous post I've outlined the hardware build of a "Robocar", a simple autonomous car platform using monocular vision and Deep Learning, using a small RC car with few modifications. The post focused exclusively on the hardware. If you've followed the directions in that post, you should be able to customize your RC car with a simple wooden or plastic platform, a…

Hello world!

Welcome to Unmanned Build, at the time known as UAV Build. When I started building my first drone some time ago, I had in the back of my mind to eventually share my DIY adventures with the community. This blog is the materialization of this idea.  I feel that at this point at last, and after several attempts, successes and failures in building DIY…